G1

Command Type
Move
Command format
G1 [{AXIS}{POSITION} E{AMOUNT} F{FEEDRATE} S{ENDSTOP_CHECK}]
Description
G1 is used to position the tool at a specific feed rate. The speed (feedrate) can be set with F*feedrate* and E *amount* amount of material can be extruded during the move. The firmware coordinates moves so that the feed rate for each axis and extruder is consistent and predictable. S can be used to check for endstops (S0: check, S1: ignore) but may not be implemented by your firmware.
Usage notes
G0 and G1 may be interpreted as the same command in some firmware.
Support
Redeem
Marlin
Smoothieware
Related
G0
Example Usage
G1 X100 Y100
Move to 100,100 on the X and Y planes